We’re not just your average safety store! Our experts know what you’re looking for and we can show you how to use it—properly. We also recertify what we sell. Check out our list below of what services we provide and what we can recertify in our shop.

Store Display #7
Store Display #8
Store Display #9
Store Display #10
Store Display #11
Store Display #12

SRL Repair & Recertification—Tripod, Lanyard & Harness Inspection

We are DBI Sala, Protecta, and MSA certified. We can repair and recertify most common DBI Sala SRL’s, Protecta Rebel SRL’s, and MSA latchway SRL models of self retracting lifelines. That means all work and repairs are done in house. We also inspect harnesses, lanyards, winches and tripods. Our experienced technician will ensure that your fallblock, lanyard, tripod, or harness meets CSA standards when it leaves our shop.

Gas Monitor Repair, Testing & Calibration

You expect to receive accurate performance from your detectors and monitors so you can work reliably and trust your readings. We are here to make sure they work for you as expected and we will take it upon ourselves to visit your site to ensure that happens. We can service, repair and calibrate all varieties of gas monitors such as MSA, BW, and Dräger. We will get yours working properly, quickly.

Breathing Apparatus & Cylinder Maintenance

We recertify most manufacturers MSA, Dräger, 3M-Scott, and Survivair both self-contained (SCBA) and supplied-air (SABA). We clean and sanitize facepieces, NIOSH test the regulators (recommended annually) and inspect the harnesses. We clean the cases and change out cylinder air with grade-E certified breathing air. We will do eddy current tests on the cylinders with our Visual Plus 3 and are also one of the few shops in Calgary equipped with a 10,000 psi high-pressure hydro-tester.

Respirator Fit Testing & Repair

Fit testing is essential for a respirator to provide protection. Facepieces for all respirators are normally available in a range of sizes to fit the majority of workers. However, it is sometimes difficult to get a tight fit with workers for a wide variety of reasons. We will work with you to ensure that the seal is not compromised by many common and some not-so-common factors including jaw movements and eyewear while still being sensitive to the wearers comfort level. We will save you time, and give you the knowledge and confidence that will save your life.

High Pressure Vessel Hydro Testing & Refilling

Big or small, we test them all! We will recertify most types of high pressure cylinders and vessels . We do high pressure hydro testing on most common types of high pressure cylinders. Our equipment can test pressures up to 10,000 psi. Orion Safety Equipment is a Transport Canada approved testing facility. We can also refill your high pressure vessels with breathing air, oxygen or nitrogen. Please phone us if you have any questions about this service.

Fire Extinguisher Recharging, Inspections and Recertification

Our shop has all of the equipment necessary to recharge, hydro test and recertify all makes and models of stored pressure fire extinguishers, wheeled unit fire extinguishers, CO₂ fire extinguishers, and fire hoses. We can inspect and recertify kitchen suppression systems as well. Our technicians have up-to-date certification to perform annual inspections of all types of fire extinguishers at your place of business to ensure that you conform to current Alberta Fire Codes and NFPA 10. We can do on site annual inspections and will leave loaner fire extinguishers in place of any units that may need work done at our shop. We can also hydro test, inspect, and recertify most common commercial use fire hoses.

Emergency Lighting Inspection and Repair

We can inspect and repair all varieties of emergency lighting. We do on-site draw analysis, battery and light bulb replacement, and if the unit is not functioning we can provide and install a new replacement.

Our Vendor Partners

Our relationships with our manufacturers allow us to provide a manufacturing representative to ensure that all of your questions or concerns about any product are dealt with in a knowledgable and reliable manner. We use only quality name brands.

  • BWA
  • MSA
  • Scott
  • Sperian
  • North
  • Petzl
  • DBI-Sala
  • Royer
  • Baffin
  • Bob Dale Gloves
  • Pioneer
  • Watson
  • Amerex
  • ASI
  • UK
  • EnviroGuard
  • Haws
  • Helly Hansen
  • IFR
  • Lakeland
  • OHD
  • Accuform
  • Capital
  • Davis
  • Edge
  • Jarvis
  • Keltek
  • Pelican
  • ROK straps
  • Safety West
  • Sure Guard
  • Zoll